Owners Manual

description
Enter a text description of the DCB policy (PFC input or ETS output).
Syntax
description text
To remove the text description, use the no description command.
Parameters
text Enter the description of the output policy. The maximum is
32 characters.
Defaults none
Command
Modes
• DCB INPUT POLICY
• DCB OUTPUT POLICY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
priority-list
Configure the 802.1p priorities for the traffic on which you want to apply an ETS output policy.
Syntax
priority-list value
To remove the priority list, use the no priority-list command.
Parameters
value Enter the priority list value. Separate priority values with a
comma; specify a priority range with a dash; for example,
priority-list 3,5-7. The range is from 0 to 7.
Defaults none
Command
Modes
PRIORITY-GROUP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Data Center Bridging (DCB)
555