Owners Manual

ip igmp access-group
To specify access control for packets, use this feature.
S4820T
Syntax
ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list
command.
Parameters
access-list Enter the name of the extended ACL (16 characters
maximum).
Defaults Not configured
Command
Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced on E-Series.
Usage
Information
The access list accepted is an extended ACL. To block IGMP reports from hosts, on
a per-interface basis based on the group address and source address that you
specify in the access list, use this feature.
ip igmp group-join-limit
To limit the number of IGMP groups that can be joined in a second, use this feature.
Z9500
Syntax
ip igmp group-join-limit number
Parameters
number Enter the number of IGMP groups permitted to join in a
second. The range is from 1 to 10000.
Internet Group Management Protocol (IGMP)
737