Owners Manual

traffic on the port channel and the individual interfaces within the port channel. To
enable a port channel, enter no shutdown on the port channel interface and at
least one interface within that port channel.
The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port channel.
Related
Commands
interface port-channel — creates a port channel interface.
interface vlan — creates a VLAN.
show ip interface — displays the interface routing status. Add the keyword brief
to display a table of interfaces and their status.
speed (for 10/100/1000 interfaces)
Set the speed for 10/100/1000 Base-T Ethernet interfaces. Set both sides of a link to the same speed
(10/100/1000) or to auto or the link may not come up.
S4820T
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed {10 | 100 | 1000}
command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
NOTE: This interface speed is not supported on the LC-
EH-GE-50P or the LC-EJ-GE-50P card. If the command
is entered for these interfaces, an error message appears.
100 Enter the keyword 100 to set the interface’s speed to 10/100
Mb/s.
NOTE: When this setting is enabled, only 100Base-FX
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
1000 Enter the keyword 1000 to set the interface’s speed to 1000
Mb/s. Auto-negotiation is enabled. For more information,
refer to negotiation auto.
NOTE: When this setting is enabled, only 100oBase-FX
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
auto Enter the keyword auto to set the interface to auto-
negotiate its speed. Auto-negotiation is enabled. For more
information, refer to negotiation auto.
820
Interfaces