Owners Manual

Defaults Enabled.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related
Commands
show ip interface — displays the interface routing status and configuration.
ip route
Assign a static route to the switch.
S4820T
Syntax
ip route [vrf vrf-name] ip-address mask {ip-address | interface
[ip-address]} [distance] [permanent] [tag tag-value] [vrf vrf-
name] [weight weight-value]
To delete a specific static route, use the no ip route destination mask
command.
To delete all routes matching a certain route, use the no ip route
destination mask command.
Parameters
vrf vrf-name (Optoinal) Enter the keyword vrf and then the name of the
VRF to configure a static route corresponding to that VRF.
Use this VRF option after the
ip route keyword to
configure a static route on that particular VRF.
894
IPv4 Routing