Owners Manual
the example, if tengig 1/1 has an ip address on subnet 2.2.2.0 and if 172.31.5.43
recursively resolves to 2.2.2.0, Dell Networking OS installs the static route.
• When the interface goes down, Dell Networking OS withdraws the route.
• When the interface comes up, Dell Networking OS re-installs the route.
• When recursive resolution is “broken,” Dell Networking OS withdraws the route.
• When recursive resolution is satisfied, Dell Networking OS re-installs the route.
You can specify a weight for an IPv4 or IPv6 static route. If the weight value of a
path is 0, then that path is not used for forwarding when weighted ECMP is in
effect. Also, if a path corresponding to a static route (destination) has a non-zero
weight assigned to it and other paths do not have any weight configured, then
regular ECMP is used for forwarding.
You can specify the weight value only to destination address and not on the egress
port.
A route is considered for weighted ECMP calculations only if each paths
corresponding to that route is configured with a weight.
You cannot use the VRF attribute of this command to configure routes in a
management VRF. When a specific VRF is deleted, all the configured static routes
corresponding to that VRF are automatically removed.
Example
Dell(conf)#ip route 1.1.1.0/24 4.4.4.2 weight 100
Dell(conf)#ip route 1.1.1.0/24 6.6.6.2 weight 200
Dell(conf)#do show running-config | grep route ip route
1.1.1.0/24 4.4.4.2 weight 100 ip route 1.1.1.0/24 6.6.6.2
weight 200
Dell(conf)#ip route vrf test 1.1.1.0/24 4.4.4.2 weight 100
Dell(conf)#ip route vrf test 1.1.1.0/24 6.6.6.2 weight 200
Dell(conf)#
Dell(conf)#do show running-config | grep route ip route vrf
test 1.1.1.0/24 4.4.4.2 weight 100 ip route vrf test
1.1.1.0/24 6.6.6.2 weight 200
Related
Commands
show ip route — views the switch routing table.
ip source-route
Enable Dell Networking OS to forward IP packets with source route information in the header.
S4820T
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source
command.
Defaults Enabled.
IPv4 Routing
897