Owners Manual

Example (Brief)
Dell#show ip interface brief
Interface IP-Address OK? Method
Status Protocol
TenGigabitEthernet 1/0 unassigned NO Manual
administratively down down
TenGigabitEthernet 1/1 unassigned NO Manual
administratively down down
TenGigabitEthernet 1/2 unassigned YES Manual
up up
TenGigabitEthernet 1/3 unassigned YES Manual
up up
TenGigabitEthernet 1/4 unassigned YES Manual
up up
TenGigabitEthernet 1/5 10.10.10.1 YES Manual
up up
TenGigabitEthernet 1/6 unassigned NO Manual
administratively down down
show ip management-route
View the IP addresses assigned to the Management interface.
S4820T
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses
assigned to all Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only
routes directly connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table
listing the number of active and non-active routes and their
sources.
static (OPTIONAL) Enter the keyword static to view non-active
routes also.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
IPv4 Routing
925