Owners Manual

static 3 0
ospf 100 1368 2
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388 2
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
Dell>
Related
Commands
show ip route — displays information about the routes found in the switch.
show ip traffic
View IP, ICMP, UDP, TCP and ARP traffic statistics.
S4820T
Syntax
show ip traffic [all | cp | rp1 | rp2]
NOTE: These options are supported only on the E-Series.
Parameters
all (OPTIONAL) Enter the keyword all to view statistics from all
processors. If you do not enter a keyword, you also view all
statistics from all processors.
cp (OPTIONAL) Enter the keyword cp to view only statistics
from the Control Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to view only the
statistics from Route Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to view only the
statistics from Route Processor 2.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
936
IPv4 Routing