Owners Manual

no-rtr-address Enter the keyword no-rtr-address to exclude the full
router address from router advertisements (the R bit is not
set).
off-link Enter the keywords off-link to advertise the prefix without
stating to recipients that the prefix is either on-link or off-
link.
valid-lifetime |
infinite
Enter the amount of time that the prefix is advertised, or
enter infinite for an unlimited amount of time. The range
is from 0 to 4294967295. The default is 2592000. The
maximum value means that the preferred lifetime does not
expire for the valid-life time parameter.
preferred-
lifetime |
infinite
Enter the amount of time that the prefix is preferred, or enter
infinite for an unlimited amount of time. The range is
from 0 to 4294967295. The default is
604800. The
maximum value means that the preferred lifetime and does
not expire.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series TeraScale, C-Series, and S-
Series.
Usage
Information
By default, all prefixes configured as addresses on the interface are advertised. This
command allows control over the individual parameters per prefix; you can use the
default keyword to use the default parameters for all prefixes. If a prefix has been
configured with lifetime parameter values, the default values cannot be applied
using the ipv6 nd prefix default no-autoconfig command.
964
IPv6 Basics