Reference Guide

274 | Content Addressable Memory (CAM)
www.dell.com | support.dell.com
The amount of space that is allocated among the sub-partitions must be equal to the amount of CAM space
allocated to IPv4Flowby the selected CAM profile (refer to Table 11-1.); Message 3 is displayed if the total
allocated space is not correct.
The minimum amount of space that can be allocated to any sub-partition is 1K, except for System flow, for
which the minimum is 4K.
To re-allocate CAM space within the IPv4Flow partition on the entire system:
FTOS(conf)#cam-ipv4flow default
FTOS#copy running-config startup-config
File with same name already exist.
Proceed to copy the file [confirm yes/no]: yes
!
3914 bytes successfully copied
FTOS#sh cam-ipv4flow
-- Chassis Cam Ipv4Flow --
Current Settings Next Boot
Multicast Fib/Acl : 8K 9K
Pbr : 2K 1K
Qos : 7K 8K
System Flow : 6K 5K
Trace Lists : 1K 1K
-- Line card 0 --
Current Settings Next Boot
Multicast Fib/Acl : 8K 9K
Pbr : 2K 1K
Qos : 7K 8K
System Flow : 6K 5K
Trace Lists : 1K 1K
-- Line card 1 --
Current Settings Next Boot
Multicast Fib/Acl : 8K 9K
Message 3 IPv4Flow Configuration Error
% Error: Total size must add up to match IPv4flow size of 24K required by the
configured profile.
Step Task Command Syntax Command Mode
1 Re-allocate CAM space within the
IPv4Flow partition.
cam-ipv4flow
CONFIGURATION
2 Save the running-configuration.
copy running-config startup-config
EXEC Privilege
3 Verify that the new CAM configuration will
be written to the CAM on the next boot.
show cam-ipv4flow
EXEC Privilege
4 Reload the system.
reload
EXEC Privilege