Reference Guide

Interfaces | 477
View Advanced Interface Information
Dell Force10 platforms provide a number of advanced viewing capabilities that control how interface
information is presented. These features are the following:
• Display Only Configured Interfaces
• Configure Interface Sampling Size
• Dynamic Counters
• Clear interface counters
Display Only Configured Interfaces
The following options have been implemented for show [ip | running-config] interfaces commands for (only)
linecard interfaces. When the
configured keyword is used, only interfaces that have non-default
configurations are displayed. Dummy linecard interfaces (created with the
linecard command) are treated
like any other physical interface.
The following example lists the possible show commands that have the configured keyword available:
FTOS#show interfaces configured
FTOS#show interfaces linecard 0 configured
FTOS#show interfaces gigabitEthernet 0 configured
FTOS#show ip interface configured
FTOS#show ip interface linecard 1 configured
FTOS#show ip interface gigabitEthernet 1 configured
FTOS#show ip interface br configured
FTOS#show ip interface br linecard 1 configured
FTOS#show ip interface br gigabitEthernet 1 configured
FTOS#show running-config interfaces configured
FTOS#show running-config interface gigabitEthernet 1 configured
In EXEC mode, the show interfaces switchport command displays only interfaces in Layer 2 mode and
their relevant configuration information. The
show interfaces switchport command as shown in the example
below displays the interface, whether the interface supports IEEE 802.1Q tagging or not, and the VLANs
to which the interface belongs.
FTOS#show interfaces switchport
Name: GigabitEthernet 13/0
802.1QTagged: True
Vlan membership:
Vlan 2
Name: GigabitEthernet 13/1
802.1QTagged: True
Vlan membership: