Reference Guide

480 | Interfaces
www.dell.com | support.dell.com
For remaining applications, FTOS automatically turns on counting when the application is enabled, and is
turned off when the application is disabled. Please note that if more than four counter-dependent
applications are enabled on a port pipe, there is an impact on line rate performance.
The following counter-dependent applications are supported by FTOS:
• Egress VLAN
• Ingress VLAN
• Next Hop 2
• Next Hop 1
• Egress ACLs
• ILM
• IP FLOW
• IP ACL
• IP FIB
• L2 ACL
• L2 FIB
Clear interface counters
The counters in the show interfaces command are reset by the clear counters command. This command
does not clear the counters captured by any SNMP program.