Reference Guide

562 | IPv6 Routing
www.dell.com | support.dell.com
Telnet with IPv6
IPv6 Telnet is supported on platforms c e s
The Telnet client and server in FTOS support IPv6 connections. You can establish a Telnet session directly
to the router using an IPv6 Telnet client, or an IPv6 Telnet connection can be initiated from the router.
SNMP over IPv6
SNMP is supported on platforms c e s
Simple Network Management Protocol (SNMP) can be configured over IPv6 transport so that an IPv6 host
can perform SNMP queries and receive SNMP notifications from a device running FTOS IPv6. The FTOS
SNMP-server commands for IPv6 have been extended to support IPv6. Refer to the
SNMP and SYSLOG
chapter in the
FTOS Command Line Interface Reference for more information regarding SNMP commands.
• snmp-server host
• snmp-server user ipv6
• snmp-server community ipv6
• snmp-server community access-list-name ipv6
• snmp-server group ipv6
• snmp-server group access-list-name ipv6
Note: Telnet to link local addresses is not supported.
Command Syntax Command Mode Purpose
telnet
ipv6 address EXEC or
EXEC Privileged
Enter the IPv6 Address for the device.
ipv6 address : x:x:x:x::x
mask : prefix length 0-128
IPv6 addresses are normally written as eight groups of four hexadecimal digits, where
each group is separated by a colon (:). Omitting zeros is accepted as described in
Addressing earlier in this chapter.