Reference Guide

Management | 73
Time out of EXEC Privilege Mode
EXEC timeout is a basic security feature that returns FTOS to the EXEC mode after a period of inactivity
on terminal lines.
To change the timeout period or disable EXEC timeout.
View the configuration using the command
show config from LINE mode.
FTOS(conf)#line con 0
FTOS(config-line-console)#exec-timeout 0
FTOS(config-line-console)#show config
line console 0
exec-timeout 0 0
FTOS(config-line-console)#
Telnet to Another Network Device
To telnet to another device:
FTOS# telnet 10.11.80.203
Trying 10.11.80.203...
Connected to 10.11.80.203.
Exit character is '^]'.
Login:
Login: admin
Password:
FTOS>exit
Task Command Syntax Command Mode
Set the number of minutes and seconds.
Default: 10 minutes on console, 30 minutes on VTY.
Disable EXEC timeout by setting the timeout period to 0.
exec-timeout minutes [seconds]
LINE
Return to the default timeout values.
no exec-timeout
LINE
Task Command Syntax Command Mode
Telnet to the peer RPM. You do not need to configure the management
port on the peer RPM to be able to telnet to it.
telnet-peer-rpm
EXEC Privilege
Telnet to a device with an IPv4 or IPv6 address. If you do not enter an IP
address, FTOS enters a Telnet dialog that prompts you for one.
• Enter an IPv4 address in dotted decimal format (A.B.C.D).
• Enter an IPv6 address in the format
0000:0000:0000:0000:0000:0000:0000:0000. Elision of zeros is
supported.
telnet [ip-address]
EXEC Privilege