Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T

1021

• Router mode — When a policy with device role as router is applied on an interface, all the RA packets are validated based on the

conguration information in the policy. Similarly, you can also apply this mode over any specic VLAN and the validation is

performed only for that particular VLAN RA packets.

To congure the IPv6 RA guard, use the following Dell Networking OS commands.

debug ipv6 nd ra-guard

Enable debugging for IPv6 RA guard snooping information.

Syntax

debug ipv6 nd ra-guard [interface_type slot/port | count value]

Parameters

interface_type slot/

port

Enter the one of the following interfaces and slot/port information:

• For a port channel interface, enter the keywords port-channel then a

number.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

count value Enter the keyword count then the number of debug outputs. The range is from 1

to 65534. The default is innity.

Defaults none

Command Modes EXEC Privilege

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.

device-role

Specify the role of the device attached to the port.

Syntax

device-role {host | router}

To reset the device role, use the no device-role {host | router} command.

Parameters

host Enter the keyword host to set the device-role as host.

router Enter the keyword router to set the device-role as router.