Users Guide

show ip pim snooping neighbor
Display information on PIM neighbors learned through PIM-SM snooping.
Syntax
show ip pim snooping neighbor [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display information about PIM neighbors that
PIM-SM snooping discovered on a specied VLAN. The valid VLAN IDs range is
from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.1.1 Introduced on the E-Series ExaScale.
Usage Information The following describes the show ip pim snooping neighbor commands shown in the following
example.
Field Description
Neighbor address Displays the IP address of the neighbor learned through PIM-SM snooping.
Interface Displays the VLAN ID number and slot/port on which the PIM-SM-enabled
neighbor was discovered.
Uptime/expires Displays the amount of time the neighbor has been up then the amount of time
until the neighbor is removed from the multicast routing table (that is, until the
neighbor hold time expires).
Ver Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode:
• 1 = default Designated Router priority (use the ip pim dr-priority
command)
• DR = Designated Router
• S = Sparse mode
Example
Dell#show ip pim snooping neighbor
PIM-Sparse Mode (PIM-SM)
1181