Users Guide
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
group-address (OPTIONAL) Enter the group address in dotted decimal format (A.B.C.D).
source-address (OPTIONAL) Enter the source address in dotted decimal format (A.B.C.D).
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage Information The following describes the show ip pim tib command shown in the following example.
Field Description
(S, G) Displays the entry in the multicast PIM database.
uptime Displays the amount of time the entry has been in the PIM route table.
expires Displays the amount of time until the entry expires and is removed from the
database.
RP Displays the IP address of the RP/source for this entry.
ags List the ags to dene the entries:
• D = PIM Dense Mode
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = Dell Networking OS is registering this entry for a multicast source
• T = packets were received via Shortest Tree Path
• J = rst packet from the last hop router is received and the entry is ready to
switch to SPT
1186
PIM-Sparse Mode (PIM-SM)