Users Guide
match ip access-group
Congure match criteria for a class map, based on the access control list (ACL).
NOTE: IPv6 class-maps and IP-any class-maps do not match. This condition is true for IPv6 and IP-any class-maps on
both ACLs as well as VLANs.
S4820T
Syntax
match ip access-group access-group-name [set-ip-dscp value | set-color
value]
To remove ACL match criteria from a class map, use the no match ip access-group access-
group-name [set-ip-dscp value | set-color value] command.
Parameters
access-group-name Enter the ACL name whose contents are used as the match criteria in determining
if packets belong to the class the class-map species.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP value. The
matched trac is marked with the DSCP value. The range is from 0 to 63.
set-color value (Optional) Enter the keyword set-color followed by a color value. Trac that fullls
the match criteria is marked with the color value that you specify. The default value
is Yellow.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (cong-class-map)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information To access this command, enter the class-map command. After the class map is identied, you can
congure the match criteria. For class-map match-any, a maximum of ve ACL match criteria are allowed.
For class-map match-all, only one ACL match criteria is allowed.
Related Commands
class-map — identies the class map.
1228
Quality of Service (QoS)