Users Guide

policy-aggregate
Allow an aggregate method of conguring per-port QoS via policy maps. An aggregate QoS policy is part of the policy map (output)
applied on an interface.
S4820T
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate conguration, use the no policy-aggregate qos-policy-name
command.
Parameters
qos-policy-name Enter the name of the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information If the rate shape exists in both aggregate and per-queue qos-policy, minimum of 2 take eect. Some of all
Queue-rate will not exceed aggregate.
Related Commands
policy-map-input — creates an input policy map.
policy-map-output — creates an output policy map.
policy-map-input
Create an input policy map.
S4820T
Syntax
policy-map-input policy-map-name cpu-qos | [layer2]
To remove an input policy map, use the no policy-map-input policy-map-name cpu-qos |
[layer2] command.
Parameters
policy-map-name Enter the name of the policy map in character format (32 characters
maximum).
cpu-qos Enter the cpu-qos keyword to assign this ACL to control plane trac only.
Quality of Service (QoS)
1233