Users Guide

• When multicast bandwidth is assigned along with unicast bandwidth, rst multicast bandwidth is
reserved for that port, then the remaining unicast bandwidth congured is adjusted according to the
bandwidth available after reserving for multicast bandwidth.
queue ingress
Assign a WRED Curve to all eight ingress Multicast queues or designate the percentage for the Multicast bandwidth queue.
Syntax
queue ingress multicast {linecard slot number port-set number | all} [wred-
profile name]
To return to the default, use the no queue ingress multicast {linecard slot number
port-set number | all} [wred-profile name] command.
Parameters
linecard number Enter the keyword linecard then the line card slot number.
port-set number Enter the keywords port-set then the line card’s port pipe. The range is from 0
or 1.
all Enter the keyword all to apply to all line cards.
wred-prole name (OPTIONAL) Enter the keywords wred-profile then your WRED prole name
in character format (16 character maximum). Or use one of the pre-dened WRED
prole names.
Pre-dened Proles: wred_drop, wred-ge_y, wred_ge_g, wred_teng_y,
wred_teng_g.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
7.4.1.0 and 6.5.3.0 Introduced on the E-Series.
Usage Information
This command does not uniquely identify a queue, but rather identies only a set of queues. The WRED
Curve is applied to all eight ingress Multicast queues.
NOTE: The multicast-bandwidth option is not supported on queue ingress. If you attempt to
use the multicast-bandwidth option, the following reject error message is generated: %
Error:Bandwidth-percent is not allowed for ingress multicast
.
1238
Quality of Service (QoS)