Users Guide

47
Routing Information Protocol (RIP)
Routing information protocol (RIP) is a distance vector routing protocol. The Dell Networking operating software supports both RIP
version 1 (RIPv1) and RIP version 2 (RIPv2) on the S4820T platform.
The Dell Networking OS implementation of RIP is based on IETF RFCs 2453 and RFC 1058. For more information about conguring
RIP, refer to the
Dell Networking OS Conguration Guide.
auto-summary
Restore the default behavior of automatic summarization of subnet routes into network routes. This command applies only to RIP
version 2.
Syntax
auto-summary
To send sub-prex routing information, use the no auto-summary command.
Defaults Enabled.
Command Modes ROUTER RIP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
1262
Routing Information Protocol (RIP)