Users Guide

To delete the lter, use the no distribute-list prefix-list-name in command.
Parameters
prex-list-name Enter the name of a congured prex list.
interface (OPTIONAL) Identies the interface type slot/port as one of the following:
• For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes ROUTER RIP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.29.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Related Commands ip prex-list — enters PREFIX-LIST mode and congures a prex list.
distribute-list out
Congure a lter for outgoing routing updates.
S4820T
Syntax
distribute-list prefix-list-name out [interface | bgp | connected | isis |
ospf | static]
1268
Routing Information Protocol (RIP)