Users Guide
show debugging
View a list of all enabled debugging processes.
Syntax
show debugging
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series
E-Series Original command.
Example
Dell#show debug
Generic IP:
IP packet debugging is on for
ManagementEthernet 0/0
Port-channel 1-2
Port-channel 5
GigabitEthernet 4/0-3,5-6,10-11,20
GigabitEthernet 5/0-1,5-6,10-11,15,17,19,21
ICMP packet debugging is on for
GigabitEthernet 5/0,2,4,6,8,10,12,14,16
Dell#
show environment
View S-Series and Z-Series system component status (for example, temperature or voltage).
Syntax
show environment [all | fan | stack-unit unit-id | pem ]
Parameters
all Enter the keyword all to view all components.
fan Enter the keyword fan to view information on the fans. The output of this command is chassis
dependent.
stack-unit unit-id Enter the keyword stack-unit then the unit-id to display information on a specic stack
member. The range is from 0 to 1.
Control and Monitoring
127