Users Guide
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information If you want the interface to receive both versions of RIP, use the ip rip receive version 1 2
command.
Related Commands
ip rip send version — sets the RIP version for sending RIP trac on an interface.
version — sets the RIP version the switch software uses.
ip rip send version
To send a specic version of RIP, set the interface. The version you set on the interface overrides the version command in ROUTER
RIP mode.
S4820T
Syntax
ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
Parameters
1 (OPTIONAL) Enter the number 1 for RIP version 1. The default is RIP version 1.
2 (OPTIONAL) Enter the number 2 for RIP version 2.
Defaults RIPv1
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Routing Information Protocol (RIP)
1271