Users Guide

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces congured with any address the network command species.
oset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
S4820T
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an oset list, use the no offset-list prefix-list-name {in | out} offset
[interface] command.
Parameters
prex-list-name Enter the name of an established Prex list to determine which incoming routes are
modied.
oset Enter a number from zero (0) to 16 to be applied to the incoming route metric
matching the access list specied. If you set an oset value to zero (0), no action is
taken.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Routing Information Protocol (RIP)
1275