Users Guide
rmon collection history
Enable the RMON MIB history group of statistics collection on an interface.
S4820T
Syntax
rmon collection history {controlEntry integer} [owner name] [buckets
number] [interval seconds]
To remove a specied RMON history group of statistics collection, use the no rmon collection
history {controlEntry integer} command.
Parameters
controlEntry integer Enter the keyword controlEntry to specify the RMON group of statistics using
a value. Then enter an integer value from 1 to 65535 that identies the RMON
group of statistics. The integer value must be a unique index in the RMON history
table.
owner name (OPTIONAL) Enter the keyword owner then the owner name to record the owner
of the RMON group of statistics.
buckets number (OPTIONAL) Enter the keyword buckets then the number of buckets for the
RMON collection history group of statistics. The bucket range is from 1 to 1000.
The default is 50.
interval seconds (OPTIONAL) Enter the keyword interval then the number of seconds in each
polling cycle. The range is from 5 to 3600 seconds. The default is 1800 seconds.
Defaults none
Command Modes CONFIGURATION INTERFACE (cong-if)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Remote Monitoring (RMON)
1289