Users Guide

ip ssh rhostsle
Specify the rhost le used for host-based authorization.
Syntax
ip ssh rhostsfile {WORD}
Parameters
WORD Enter the rhost le name for the host-based authentication.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Example
Dell#conf
Dell(conf)# ip ssh rhostsfile flash://shosts
Dell(conf)#
Usage Information
This command species the rhost le used for host-based authentication. This creates/ le overwrites
the flash:/ADMIN_DIR/ssh/shosts le and deletes the user-specied le. Even though this
command is a global conguration command, it does not appear in the running conguration because you
only need to run this command once.
This le contains hostnames and usernames, for which hosts and users, rhost-authentication can be
allowed.
NOTE: For rhostfile and pub-key-file, the administrator must FTP the le to the switch.
ip ssh rsa-authentication (Cong)
Enable RSA authentication for the SSHv2 server.
Syntax
ip ssh rsa-authentication enable
To disable RSA authentication, use the no ip ssh rsa-authentication enable command.
Security
1375