Users Guide
Version Description
7.4.1.0 Introduced
Usage Information When you enable VLAN-Stacking, no protocol packets are tunneled.
Related Command show protocol-tunnel — displays tunneling information for all VLANs.
protocol-tunnel enable
Enable protocol tunneling globally on the system.
Syntax
protocol-tunnel enable
To disable protocol tunneling, use the no protocol-tunnel enable command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.4.1.0 Introduced
Usage Information Dell Networking OS must have the default CAM prole with the default microcode before you enable L2PT.
protocol-tunnel rate-limit
Enable trac rate limiting per box.
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate command.
Parameters
rate Enter the rate in frames per second. The range is from 75 to 3000. The default is
75.
Defaults 75 frames per second.
Command Modes CONF-IF-VLAN-STACK
Service Provider Bridging
1401