Users Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information This command changes the sampling rate for an interface. By default, the sampling rate of an interface is set
to the same value as the current global default sampling rate. If the value entered is not a correct power of
2, the command generates an error message with the previous and next power-of-2 value. Select one of
these two number and re-enter the command.
Related Commands sow sample-rate (Global) — changes the sampling rate globally.
show sow
Display the current sFlow conguration.
Syntax
show sflow [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information. The slot range is from
0 to 1. The port range is 0.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 100/1000 Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
Command Modes
• EXEC
• EXEC Privilege
1412
sFlow