Users Guide

• For a port channel interface, enter the keywords port-channel then a
number.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address assigned to the management interface is the default.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information To enable this snmp-server trap-source command, congure an IP address on the interface and
enable the interface congured as an SNMP trap source.
Related Commands snmp-server community — sets the community string.
snmp-server user
Congure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address vrf vrf-name udp-port
port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password]
[priv {des56 | aes128} priv password] [access access-list-name | ipv6
access-list-name | access-list-name ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name {group_name
remote ip-address vrf vrf-name udp-port port-number} [1 | 2c | 3]
[encrypted] [auth {md5 | sha} auth-password] [priv {des56 | aes128} priv
password] [access access-list-name | ipv6 access-list-name | access-list-
name ipv6 access-list-name] command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host that
connects to the agent.
1430
Simple Network Management Protocol (SNMP) and Syslog