Users Guide

Version Description
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related Commands
logging monitor — sets the logging monitor parameters.
terminal monitor — sends system messages to the terminal/monitor.
default logging trap
Return to the default settings for logging messages to the Syslog servers.
Syntax
default logging trap
Defaults level = 6 or informational
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related Commands logging trap — limit messages logged to the Syslog servers based on severity.
logging
Congure an IP address or host name of a Syslog server where logging messages are sent. Multiple logging servers of both IPv4
and/or IPv6 can be congured.
Syntax
logging {ip-address | ipv6-address | hostname} {{udp {port}} | {tcp {port}}
[vrf vrf-name]
To disable logging, use the no logging command.
Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
Simple Network Management Protocol (SNMP) and Syslog
1439