Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T

1531

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

Defaults Not congured.

Command Modes CONF-IF-VLAN

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.11.1 Introduced on the Z9000.

8.2.1.0 Introduced on the E-Series ExaScale.

7.6.1.0 Introduced on the C-Series and S-Series.

Usage Information You must enable the stackable VLAN (using the vlan-stack compatible command) on the VLAN

prior to adding a member to the VLAN.

Related Commands vlan-stack compatible — enables stackable VLAN on a VLAN.

stack-unit stack-group

Congure a stacking group specied by an ID.

Syntax

[no] stack-unit unit-id stack-group stack-group-id

Parameters

unit-id Enter the stack unit ID.

stack-group-id Enter the stack group ID. The range is from 0 to 16.

[no] Use no stack-unit unit-id stack-group stack-id to remove the

current stack group conguration.

Command Modes CONFIGURATION