Users Guide
Usage Information
WARNING: The following message displays to conrm the command: All non-default
configurations on the related member ports ports (<ports listed here>)
will be removed. Do you want to continue (y/n)? If you enter “y”, all non-default
congurations on any member ports of the current stack group is removed when the unit is
rebooted.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
E-Series original
Command
Usage Information
Prior to enabling this command, to place the interface in Layer 2 mode, enter the switchport command.
To remove the access port designation, remove the port (using the no member interface command)
from all stackable VLAN enabled VLANs.
vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
Syntax
vlan-stack compatible
1534
VLAN Stacking