Users Guide

If you set the priority command to 255 and the virtual-address is not equal to the interface’s
primary IP address, an error message appears.
show cong
View the non-default VRRP conguration.
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group conguration
information, including defaults.
Command Modes VRRP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(conf-if-vrid-4)#show config
vrrp-group 4
virtual-address 119.192.182.124
!
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns No Active VRRP group.
S4820T
Syntax
show vrrp [vrrp-id] [vrf vrf-name] [interface] [brief][ipv6]
Parameters
vrrp-id (OPTIONAL) Enter the Virtual Router Identier for the VRRP group to view only that group. The range is from 1 to
255.
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to view active VRRP groups corresponding to
that VRF.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
1584
Virtual Router Redundancy Protocol (VRRP)