Users Guide

• For a VLAN interface, enter the keyword vlan followed by the VLAN ID. The
VLAN ID range is from 1 to 4094.
priority-cost (OPTIONAL) Enter a number as the amount to be subtracted from the priority
value. The range is 1 to 254. The default is 10.
Defaults priority cost = 10
Command Modes VRRP
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information If the interface is disabled, the cost value is subtracted from the priority value and forces a new MASTER
election if the priority value is lower than the priority value in the BACKUP virtual routers.
version
Set VRRP protocol version for IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2 Enter the 2 parameter to specify VRRP version 2 as dened by RFC 3768, Virtual
Router Redundancy Protocol.
3 Enter the 2 parameter to specify VRRP version 3 as dened in RFC 5798, Virtual
Router Redundancy.
both Enter the both keyword for in-service migration from VRRP version 2 to VRRP
version 3.
Defaults 2
Command Modes VRRP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
1588
Virtual Router Redundancy Protocol (VRRP)