Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series. Support was added for
IPv6 VRRP groups in non-default VRF instances.
8.3.2.0 Introduced on the E-Series TeraScale.
Usage Information If no options are specied, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns No Active VRRP
group.
Syntax
show vrrp ipv6 [vrid] [interface] [brief] [vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the virtual router identier for the VRRP group to view only
that group. The range is from 1 to 255.
interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number.
•
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the
VRRP groups.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to view IPv6 VRRP groups
corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series TeraScale.
Usage Information The following describes the show vrrp ipv6 command shown in the following example.
1594
Virtual Router Redundancy Protocol (VRRP)