Users Guide

Parameters
access-list-name (OPTIONAL) Enter the name of a congured access-list, up to 140 characters.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increase the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
ip access-group
Assign an IP access list (IP ACL) to an interface.
Syntax
ip access-group access-list-name {in | out} [implicit-permit] [vlan vlan-
id] [vrf vrf-name]
To delete an IP access-group conguration, use the no ip access-group access-list-name {in
| out} [implicit-permit] [vlan vlan-id] [vrf vrf-name] command.
Parameters
access-list-name Enter the name of a congured access list, up to 140 characters.
in Enter the keyword in to apply the ACL to incoming trac.
out Enter the keyword out to apply the ACL to outgoing trac.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the default action
of the ACL from implicit-deny to implicit-permit (that is, if the trac does not
match the lters in the ACL, the trac is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the ID numbers of the VLANs. The
range is from 1 to 4094 (you can use IDs from 1 to 4094).
vrf vrf-name (OPTIONAL) Enter the keyword vrf then the ID numbers of the VRFs. The range is
from 1 to 63 (you can use IDs from 1 to 63).
Access Control Lists (ACL)
195