Users Guide

Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series ExaScale (IPv6).
8.1.1.0 Introduced on the E-Series ExaScale (IPv4).
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
When you have exhausted all the sequence numbers, this feature permits re-assigning a new sequence
number to entries of an existing access-list.
resequence prex-list ipv4
Re-assign sequence numbers to entries of an existing prex list.
Syntax
resequence prefix-list ipv4 {prefix-list-name StartingSeqNum Step-to-
increment}
Parameters
prex-list-name Enter the name of the congured prex list, up to 140 characters long.
StartingSeqNum Enter the starting sequence number to resequence. The range is from 0 to 65535.
Step-to-Increment Enter the step to increment the sequence number. The range is from 1 to 65535.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Access Control Lists (ACL)
203