Users Guide

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage Information
When you have exhausted all the sequence numbers, this feature permits re-assigning a new sequence
number to entries of an existing prex list.
Related Commands resequence access-list — resequences an access-list.
seq
Assign a sequence number to a deny or permit lter in an IP access list while creating the lter.
Syntax
seq sequence-number {deny | permit} {source [mask] | any | host ip-
address}} [count [bytes]] [dscp value] [order] [fragments] [no-drop]
To delete a lter, use the no seq sequence-number command.
Parameters
sequence-number Enter a number from 0 to 4294967290. The range is from 0 to 65534.
deny Enter the keyword deny to congure a lter to drop packets meeting this
condition.
permit Enter the keyword permit to congure a lter to forward packets meeting this
criteria.
source Enter an IP address in dotted decimal format of the network from which the packet
was received.
mask (OPTIONAL) Enter a network mask in /prex format (/x) or A.B.C.D. The mask,
when specied in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the lter.
host ip-address Enter the keyword host then the IP address to specify a host IP address or
hostname.
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
bytes (OPTIONAL) Enter the keyword bytes to count bytes the lter processes.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS order for the ACL
entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the
lowest; lower-order numbers have a higher priority). If you do not use the keyword
order, the ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
204
Access Control Lists (ACL)