Users Guide
mac-destination-
address-mask
Specify which bits in the MAC address must be matched.
The MAC ACL supports an inverse mask; therefore, a mask of :::: : allows
entries that do not match and a mask of 00:00:00:00:00:00 only allows entries that
match exactly.
ethertype operator (OPTIONAL) To lter based on protocol type, enter one of the following
Ethertypes:
• ev2 - is the Ethernet II frame format.
• llc - is the IEEE 802.3 frame format.
•
snap - is the IEEE 802.3 SNAP frame format.
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the lter processes.
log (OPTIONAL, E-Series only) Enter the keyword log to log the packets.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the trac
that you want to monitor and the ACL in which you are creating the rule is applied
to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring section in
the Port Monitoring chapter of the
Dell Networking OS Conguration
Guide
.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not congured.
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Added the no-drop parameter.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information
When you use the log option, the CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
240
Access Control Lists (ACL)