Users Guide

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information The continue feature allows movement from one route-map entry to a specic route-map entry (the
sequence number). If you do not specify the sequence number, the continue feature simply moves to the
next sequence number (also known as an implied continue). If a match clause exists, the
continue feature
executes only after a successful match occurs. If there are no successful matches, the continue feature is
ignored.
Match clause with Continue clause
The continue feature can exist without a match clause. A continue clause without a match clause
executes and jumps to the specied route-map entry.
With a match clause and a continue clause, the match clause executes rst and the continue clause next in
a specied route map entry. The continue clause launches only after a successful match. The behavior is:
• A successful match with a continue clause, the route map executes the set clauses and then goes to the
specied route map entry upon execution of the continue clause.
• If the next route map entry contains a continue clause, the route map executes the continue clause if a
successful match occurs.
• If the next route map entry does not contain a continue clause, the route map evaluates normally. If a
match does not occur, the route map does not continue and falls through to the next sequence number,
if one exists.
Set Clause with Continue Clause
If the route-map entry contains sets with the continue clause, set actions are performed rst then the
continue clause jumps to the specied route map entry.
• If a set action occurs in the rst route map entry and then the same set action occurs with a dierent
value in a subsequent route map entry, the last set of actions overrides the previous set of actions with
the same set command.
• If set community additive and set as-path prepend are congure, the communities and
AS numbers are prepended.
Related Commands
set community — species a COMMUNITY attribute.
248
Access Control Lists (ACL)