Users Guide

set tag — specify the tag assigned to redistributed routes.
set comm-list delete
To remove the specied community list from the BGP route’s COMMUNITY attribute, congure a lter.
Syntax
set comm-list community-list-name delete
To insert the community list into the COMMUNITY attribute, use the no set comm-list community-
list-name delete command.
Parameters
community-list-
name
Enter the name of an established Community list, up to 140 characters.
Defaults Not congured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information
The community list used in the set comm-list delete command must be congured so that each
lter contains only one community. For example, the lter deny 100:12 is acceptable, but the lter deny
120:13 140:33
results in an error.
If the set comm-list delete command and the set community command are congured in the
same route map sequence, the deletion command (
set comm-list delete) is processed before the
insertion command (set community).
Related Commands
match community — redistributes routes that match the COMMUNITY attribute.
set community — species a COMMUNITY attribute.
Access Control Lists (ACL)
261