Users Guide

ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to reset
ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to reset
ipv6 unicast routes.
soft (OPTIONAL) Enter the keyword soft to reset soft conguration.
in Enter the keyword in to re-congure soft inbound updates.
out Enter the keyword out to re-congure soft outbound updates.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notications, and updates.
S4820T
Syntax
debug ip bgp [ vrf vrf-name | A.B.C.D | X:X:X:X::X | peer-group peer-group-
name] [in | out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to debug BGP information
corresponding to that VRF.
NOTE: Use this attribute to debug BGP protocol operations corresponding
to either a default or non-default VRF.
A.B.C.D Enter the IPv4 address of the neighbor in dotted decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
Enter the keywords peer-group then the name of the peer group to debug.
in (OPTIONAL) Enter the keyword in to view only information on inbound BGP
routes.
364
Border Gateway Protocol