Users Guide
debug ip bgp events
Display information on local BGP state changes and other BGP events.
S4820T
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group peer-group-
name] events [in | out]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X |
peer-group peer-group-name] events [in | out] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to display
BGP state changes corresponding to that VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group then the name of the peer group.
in (OPTIONAL) Enter the keyword in to view only events on inbound BGP
messages.
out (OPTIONAL) Enter the keyword out to view only events on outbound BGP
messages.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
To remove all congured debug commands for BGP, enter the no debug ip bgp command.
Border Gateway Protocol
367