Users Guide

X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all routers
within the peer group..
Defaults Disabled
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage Information
This command turns on BGP soft-reconguration inbound debugging. If no neighbor is specied, debug
turns on for all neighbors.
debug ip bgp updates
Allows you to view information about BGP updates.
S4820T
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group peer-group-
name] updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X |
peer-group peer-group-name] updates [in | out | prefix-list prefix-list-
name] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view BGP
updates information corresponding to that VRF.
A.B.C.D (OPTIONAL) Enter an IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group followed by the name of the peer
group.
in (OPTIONAL) Enter the keyword in to view only BGP updates received from
neighbors.
370
Border Gateway Protocol