Users Guide

Version Description
pre-7.7.1.0 Introduced.
Related Commands
router bgp — enters ROUTER mode on the switch.
deny bandwidth
Enables you to specify link band width extended-community attribute as the matching criteria to deny incoming or outgoing trac.
Syntax
deny bandwidth
To disable this setting, enter the no deny bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to specify extended-community attribute as the
matching criteria for denying trac. The range is from 0 to 102400.
Defaults N/A
Command Modes EXTENDED COMMUNITY LIST
Command History
Version Description
9.7(0.0) Introduced on the S-Series.
Related Commands permit bandwidth – specify link band width extended-community attribute as the matching criteria to
permitting incoming or outgoing trac..
maximum-paths
Congure the maximum number of parallel routes (multipath support) BGP supports.
S4820T
Syntax
maximum-paths {ebgp | ibgp} number
To return to the default values, enter the no maximum-paths command.
Parameters
ebgp Enter the keyword ebgp to enable multipath support for External BGP routes.
ibgp Enter the keyword ibgp to enable multipath support for Internal BGP routes.
number Enter a number as the maximum number of parallel paths. The range is from 2 to
64.
Defaults none
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
Border Gateway Protocol
373