Users Guide

as-number Clear and reapply policies for all neighbors belonging to the AS. The range is from 0
to 65535 (2 Byte), from 1 to 4294967295 (4 Byte), or from 0.1 to 0.65535.65535
(Dotted format).
ipv4-neighbor-addr
| ipv6-neighbor-
addr
Clear and reapply policies for a neighbor.
peer-group name Clear and reapply policies for all BGP routers in the specied peer group.
ipv6 unicast Clear and reapply policies for all IPv6 unicast routes.
in Reapply only inbound policies.
NOTE: If you enter soft, without an in or out option, both inbound and
outbound policies are reset.
out Reapply only outbound policies.
NOTE: If you enter soft, without an in or out option, both inbound and
outbound policies are reset.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced on the E-Series TeraScale.
debug ip bgp ipv6 unicast soft-reconguration
Enable soft-reconguration debugging for IPv6 unicast routes.
S4820T
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv6 unicast
soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-address | peer-
group-name] ipv6 unicast soft-reconfiguration command.
Parameters
ipv4-address | ipv6-
address
Enter the IP address of the neighbor on which you want to enable soft-
reconguration debugging.
peer-group-name Enter the name of the peer group on which you want to enable soft-
reconguration debugging.
448
Border Gateway Protocol