Users Guide
12
Control Plane Policing (CoPP)
The CoPP commands are supported on the Dell Networking S4820T platform.
control-plane-cpuqos
To manage control-plane trac, enter control-plane mode and congure the switch.
S4820T
Syntax
control-plane-cpuqos
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
ip unknown-unicast
Enable IPv4 catch-all route.
S4820T
Syntax
ip unknown-unicast [vrf vrf-name]
To remove the IPv4 catch-all route (0.0.0.0/0) from the LPM route forwarding table in hardware which gets
added as a default conguration after the initialization of FIB Agent module, use the no ip unknown-
unicast command.
Defaults None
Control Plane Policing (CoPP)
461