Users Guide

Defaults None. There are no pre-congured PFC and ETS settings on S5000 Ethernet interfaces.
Command Modes CONFIGURATION
INTERFACE
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage Information
A DCB map is a template used to congure DCB parameters and apply them on converged Ethernet
interfaces. DCB parameters include priority-based ow control (PFC) and enhanced trac selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map command.
Use the dcb-map command to create a DCB map to specify PFC and ETS settings and apply it on Ethernet
ports. After you apply a DCB map to an interface, the PFC and ETS settings in the map are applied when
the Ethernet port is enabled. DCBx is enabled on Ethernet ports by default.
The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name command in Interface
conguration mode.
priority-pgid
Assign 802.1p priority trac to a priority group in a DCB map.
Syntax
priority-pgid dot1p0_group-num dot1p1_group-num dot1p2_group-num
dot1p3_group-num dot1p4_group-num dot1p5_group-num dot1p6_group-num
dot1p7_group-num
Parameters
dot1p0_group-num Enter the priority group number for each 802.1p class of trac in a DCB map.
dot1p1_group-num
dot1p2_group-num
dot1p3_group-num
dot1p4_group-num
dot1p5_group-num
dot1p6_group-num
dot1p7_group-num
Defaults None
Command Modes DCB MAP
Data Center Bridging (DCB)
497