Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T
51525354555657585960
To enter MONITOR SESSION mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the monitor session command then the session ID. The prompt changes to include (conf-mon-sess-sessionID).
MULTIPLE SPANNING TREE (MSTP) Mode
To enable and congure MSTP, use MULTIPLE SPANNING TREE mode. For more information, refer to Multiple Spanning Tree
Protocol (MSTP).
To enter MULTIPLE SPANNING TREE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol spanning-tree mstp command. The prompt changes to include (conf-mstp).
You can return to CONFIGURATION mode by using the exit command.
OPENFLOW INSTANCE Mode
To enable and congure OpenFlow instances, use OPENFLOW INSTANCE mode.
To enter OPENFLOW INSTANCE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the openflow of-instance command then the OpenFlow ID number of the instance you want to create or
congure. The prompt changes to include (conf-of-instance
of-id).
You can return to the CONFIGURATION mode by entering the exit command.
Per-VLAN SPANNING TREE (PVST+) Plus Mode
To enable and congure the Per-VLAN Spanning Tree (PVST+) protocol, use PVST+ mode. For more information, refer to Per-VLAN
Spanning Tree Plus (PVST+).
NOTE: The protocol name is PVST+, but the plus sign is dropped at the CLI prompt.
To enter PVST+ mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol spanning-tree pvst command. The prompt changes to include (conf-pvst).
You can return to CONFIGURATION mode by using the exit command.
PORT-CHANNEL FAILOVER-GROUP Mode
To congure shared LAG state tracking, use PORT-CHANNEL FAILOVER-GROUP mode. For more information, refer to Port
Channel Commands.
To enter PORT-CHANNEL FAILOVER-GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the port-channel failover-group command. The prompt changes to include (conf-po-failover-grp).
You can return to CONFIGURATION mode by using the exit command.
PREFIX-LIST Mode
To congure a prex list, use PREFIX-LIST mode.
To enter PREFIX-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
CLI Basics
53