Users Guide
If disabled, the CLI would inform the FIB to re-program the destination prex paths with no weights or
regular ECMP.
Example
Dell(conf)#ip ecmp ?
weighted Enables Weighted ECMP
Dell(conf)#ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
ip ecmp weighted
Dell(conf)#
Dell(conf)#no ip ecmp ?
weighted Disables Weighted ECMP
Dell(conf)#no ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
link-bundle-distribution trigger-threshold
Provides a mechanism to set the threshold to trigger when trac distribution begins being monitored on an ECMP link bundle.
S4820T
Syntax
link-bundle-distribution trigger-threshold [percent]
To exit from ecmp group mode, use the exit command.
Parameters
percent Indicate the threshold value when trac distribution starts being monitored on an
ECMP link bundle. The range is from 1 to 90%. The default is 60%.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
Equal Cost Multi-Path (ECMP)
577